7.1

COMMON OPERATIONS AND CONCEPTS
51
Inspector segment displays
The segment displays in the Inspector can be edited as shown in the following Position display examples. The Posi-
tion display segments show (from left to right) Bars, Beats, 1/16th Note and Ticks:
The other segment displays in the sequencer Inspector can be edited in the same way as described above.
Tool Tips
If you hover with the mouse over a control on a device panel and wait a moment, a tool tip appears. The tool tip shows
the name of the parameter associated with that control and its current value. This helps you fine-tune settings, set
several parameters to the same value, etc.
D You can turn off the Tool Tips function by deactivating the option “Show parameter value tool tip” in the “Ap-
pearance” section on the General page in Preferences.
Click the up/down buttons to change the value in
steps of 1 Bar (the leftmost segment).
Click in the display to select either the Bar, Beat,
1/16th note or Ticks segment. Then, click the up/
down buttons to change the value of the selected
segment in steps of 1 unit.
Click in the display to select either Bar, Beat,
1/16th note or Ticks. Then, click and drag the
cursor up/down to change in steps of 1 unit.
Double-click in the display. Then, type in the
desired value and press [Enter].
Click in the display to select either Bar, Beat,
1/16th note or Ticks. Then, type in a number and
press [Enter].
Alternatively, select a segment, type in a number
preceded by a [+] to add or a [-] to subtract the
number from the current value. Then, press [Enter].