12.25

GRAIN SAMPLE MANIPULATOR780
Modulation Bus Source parameters.
2. Set the Amount for the first Destination by turning the corresponding Amount knob, or by clicking and drag-
ging vertically in the corresponding Amount box.
! Note that the Amount range is +/-100. This means that the Amount value can exceed the modulated parame-
ter’s range. When this happens, the modulated parameter simply stays at its extreme value until the Amount
value gets within the parameter’s range again.
3. Select the first Destination parameter by click-holding the grey arrow symbol to the right of the corresponding
Destination box.
The arrow symbol turns blue.
4. While click-holding, drag to the desired destination parameter on the panel:
Assigning LFO 1 Rate as a Destination for Envelope 1.
As you hover over a valid destination control on the panel, the parameter name is automatically displayed in the
Destination box in the Modulation Bus.
5. To assign the currently selected Destination control, release the mouse button.
! Dragging to the Waveform Display (see “The Sample section”) will always assign the playback Position
parameter. To assign the sample Start Position or End Position, select the parameter from the list (see below).
D Alternatively, click the desired Destination box and select the Destination parameter from the list.
The following parameters can be used as modulation Destinations:
Display Y Position This allows you to modulate parameters based on the mouse pointer’s Y position in the sample window.
See “Automating sample playback parameters from the sequencer” for an example.
Display Mouse Gate This allows you to modulate parameters based on the clicking/holding the mouse in the sample window.
See “Automating sample playback parameters from the sequencer” for an example.
CV Input 1/2/3/4 This takes the current value on the CV 1/CV 2/CV 3/CV 4 inputs on the rear panel and sends to the
desired destination.
CV Input 1/2/3/4 Latched This allows you to modulate parameters based on the current CV 1/CV 2/CV 3/CV 4 value at a given
Note On.
|
Parameter
|
Description
Position This affects the sample “playhead” position in the original sample.
Speed This affects the Speed control in the sample window.
Jitter This affects the Jitter control in the sample window.
Start Position This affects the Sample Start marker position in the original sample.
End Position This affects the Sample End marker position in the original sample.
Pitch This affects the pitch of the original sample.
Octave This affects the Oct control in the Playback Algorithm section.
Formant This affects the Formant Form control in the Playback Algorithm section (if applicable).
|
Parameter
|
Description