12.25

THE COMBINATOR1331
Wheel CV In and Source CV In
In this section you will find standard CV Pitch Bend and Mod Wheel modulation inputs, as well as eight modulation in-
puts which can be assigned as Sources in the Editor. Here you can connect external CV modulation sources for mod-
ulating any of the Target parameters in the Editor (see “Using Modulation Routing”).
D Click the Editor button to show the Wheel CV In and Source CV In connectors on the rear panel:
Next to each CV Input are one sensitivity knob and one polarity switch that work as follows:
• The sensitivity knobs can be used for attenuating the CV Input signal.
• The polarity switches should be used for defining the polarity of the CV Input signal.
For example, if you have connected a CV signal from an envelope generator, the switch should be set to Unipolar.
If you are modulating from a standard LFO, the polarity switch should be set to Bipolar.