12.25

THE COMBINATOR1329
Controlling multiple Target parameters differently from a single Source control
You can also have the same Source control assigned to multiple Target parameters on the same device. In the exam-
ple below the “Eng1 Filter Freq” and the “Eng1 Filter Reso” parameters on the Spectral Filter in a Europa device are
assigned to the same FILTER control on the Combinator panel:
The “Eng1 Filter Reso” parameter Range is reduced and reversed (light gray Range bar), so when you turn up the
FILTER knob on the Combinator panel, the Filter Frequency is raised but the Resonance is decreased. The “Eng1 Fil-
ter Reso” parameter also has the Source Range set to 0-50%, which means the Resonance will decrease only during
the first half of the FILTER knob range.
The picture below shows how the “Eng1 Filter Freq” and “Eng1 Filter Reso” parameters are affected when you turn
up the FILTER knob on the Combinator panel. You can also see the differences in the Spectral Filter display:
Controlling both the Freq and Reso parameters from the FILTER control on the Combinator panel.
Controlling a single Target parameter from multiple Source controls
This is also possible, by simply selecting the same Target parameter from different Source controls in the Modulation
Routing section.