12.25

SYNCHRONOUS TIMED EFFECT MODULATOR1268
Reverb
Amount knob
D Adjust the balance between the unprocessed and the reverberated audio signal.
Decay knob
D Set the decay time of the reverberated signal.
Size knob
D Set the emulated room size, from small room to large hall, with the Size knob.
Lowering this parameter results in a closer and gradually more “canned” sound. Raising the parameter results in a
more spacey sound, with longer pre-delay.
Damp knob
D Set the high-frequency damping amount of the reverberated signal.
Raising the Damp value cuts off the high frequencies of the reverb, thereby creating a smoother, warmer effect.
Send/Return switch
D Select whether you want the Amount knob to control the Send level or the Return level of the reverb effect.
The picture below shows the different configurations schematically:
The schematic placement of the Amount knob in Send and Return mode, respectively.
q To create gated or “reversed” reverb effects, set the switch to Return and modulate the Amount Modulation
parameter from a modulation curve.
Reverb On/Off button
D Click to switch on/off the Reverb effect section.
If switched off, the signal is bypassed from the Reverb section.
Reverb
Amount
Audio In Audio Out
Decay
Reverb
Amount
Audio In Audio Out
Decay
Send Return Send Return