12.25

SYNCHRONOUS TIMED EFFECT MODULATOR1263
2. Set the modulation amount for the corresponding effect parameter by turning the desired Modulation Control
knob.
Setting the modulation amount.
A colored semicircle appears around the Modulation Control knob. The semicircle shows how much the selected
modulation curve affects the corresponding effect parameter (below each Modulation Control knob) - and in which
direction (positive or negative).
D If you want the selected modulation curve to modulate other effect parameters, adjust the Modulation Control
knobs above the other desired effect parameters.
3. If you want other modulation curves to modulate the same - or other - effect parameters, click the desired
Curve Activate button and repeat the modulation assignment procedure from Step 1.
All Modulation Control knobs can be modulated by all three modulation curves at the same time if you like. The
modulation amounts and directions can be set independently for each modulation curve. The picture below shows
a Modulation Control knob which is affected differently by all three modulation curves:
Different modulation amounts set for each of the three modulation curves.
Dist section
Amount knob
D Set the distortion amount.
At 0, the signal is left unaffected.
Character knob
D Set the frequency content of the distorted signal.
The effect varies depending on the selected distortion type (see below).