12.25

SYNCHRONOUS TIMED EFFECT MODULATOR1262
FRZ (freeze) buttons
1. Click a FRZ (freeze) button to stop the playback of the corresponding modulation curve and freeze its current
modulation value.
2. Click again to deactivate the freeze function.
The playback automatically continues at the position in the loop where it should have been if the freeze function
had not been activated.
Kill buttons
1. Click a Kill button to deactivate (mute) the corresponding modulation curve.
The modulation curve is preserved but does not modulate any parameter as long as the Kill function is active. Also,
the killed curve becomes invisible in the display.
2. Click again to deactivate the Kill function.
The modulation curve is activated and automatically continues with the modulation at the current position in the
loop.
Modulation controls
The Modulation Control knobs are used for setting a modulation amount (positive or negative) for the effect
parameter right below each Modulation Control knob. To set up a modulation, proceed as follows:
1. Select the modulation curve you want to use for the modulation by clicking its Curve Activate button.
All assignable Modulation Control knobs are automatically colored according to the selected modulation curve: