10.0

EUROPA SHAPESHIFTING SYNTHESIZER
717
Blend
D Set the mix between the original signal and the duplicates.
For even “Count” numbers (see above), one of the duplicates represents the original signal in the mix.
Detune
D Set the pitch detuning of the signal duplicates.
If the “Phase Only” Unison type is selected (see above), the Detune knob controls the phases of the signal dupli-
cates instead of the pitch detuning.
q In the “Phase Only” scenario it could also be a good idea to modulate the Detune parameter from an LFO
using the Modulation Bus (see “The Modulation Bus section”), to create nice phasing effects.
Spread
D Set the stereo spread amount of the signal duplicates.
The Mixer section
The Mixer section is where you mix and pan the signals from the three Sound Engines before sending them to the
Filter, Amp and Multi FX sections.
Level
D Set the volume of the corresponding Sound Engine signal with the Level slider.
Range: -Inf to +6.0dB.
Pan
D Set the panning of the corresponding Sound Engine signal in the stereo panorama.
The Filter section
Routing buttons
D Click the red LED buttons to route the corresponding Sound Engine signals to the Filter section.
If deactivated, the signal bypasses the Filter section and goes straight to the Amp section, see “The Amplifier sec-
tion”.