Installation & Assembly

Page 21
StormRider Trampoline Anchor Kit
Trampolines, especially those with an Enclosure, can be blow around
and severely damaged by wind. It is highly recommended that you
secure your Trampoline against wind. Some Trampoline models include
one of our StormRider Anchor Kits; if so, please follow the instructions
on this page to install it correctly. More information about this Anchor
Kit and a selection of other accessories may be found on page 28.
Anchor Kits may also be purchased at www.PropelTrampolines.com.
Step 1- Evenly space the stakes around the perimeter of your trampoline.
Step 2- Using a rubber mallet, pound each stake at a 45 degree angle
into the ground until it is flush with ground level.
Step 3- Secure the Straps to the Frame of the Trampoline by looping the
Strap over the Frame and following back through the Ladder Locks, then
looping back up though the lower Ladder Lock. See illustrations below.
NOTE: To ensure the effectiveness of your Anchor Kit, keep Straps tight at all times.
This completes the installation of your StormRider Anchor Kit.
Warning; The installation and use of an Anchor Kit does not guarantee that your Trampoline will not be damaged by wind or other
severe weather. Many factors, such as soil types, influence the effectiveness of this product. If using this product in sandy or loose soil
or in a high wind area, it is recommended you purchase and use two Anchor Kits, as well as take other precautions including
disassembling Trampoline during times of severe weather. Using an Anchor Kit is not an insurance policy, and will not add additional
warranty benefits to your Trampoline. Propel Trampolines, including its retailers and affiliates, will not be held responsible for
damages to persons or property as a result of the failure of this product.