Installation & Assembly

Page 15
Step 4 – Locate the Bungee Straps sewn to the top edge of the Enclosure and connect all
Bungee Loops with Bolts to your Enclosure Net by inserting the Bolt up through the Net
Loop and bringing it down through the resulting Loop in the Bungee Cord, as shown in the
illustrations below.
Step 5 – Insert the Bungee Cord Bolt through the hole near the
top of the Enclosure Post and secure it with the corresponding Nut.
Adequately tighten the Nut with a wrench. Repeat this procedure
for each remaining Enclosure Post.
Step 6 – Stand each Post upright with the curved section facing
outward. Insert the bottom end of the Post into its corresponding T-
Bracket slot. This eliminates the need for a stepladder, allowing
the Enclosure to be completely erected from ground level. Repeat
this process for the remaining Upright Posts.
DO NOT Bolt the Enclosure Posts in place as part of this step.
This will be completed later, as the last step in assembling your Trampoline.