Installation & Assembly

Page 14
Mat and Enclosure Assembly
Read and understand all assembly instructions before beginning the assembly process.
This Trampoline Should not be installed without the included Enclosure.
Step 1 – Unfold and lay the Mat (Jumping Surface) on the ground inside the Trampoline
Frame. Make sure the Warning Labels are facing up.
Step 2 – Hook the Mat to the Frame by attaching one Spring in each corner of the frame.
(See illustration below.) To attach a Spring, hook the short end to a V-Ring sewn to the
Mat, pull the Spring back towards the Frame, insert the long end of the Spring into a slot in
the Frame, and release.
Caution: We recommend wearing leather gloves while attaching the Springs.
Be careful where you place your hands, as the Spring and Frame joints can pinch.
DO NOT attach all of the springs in this step.
Step 3 – Unfold the Enclosure Netting. Locate the zipper opening and ensure that the
warning labels are facing outwards. Align the zipper so that is it faces the end of the
trampoline.