Owners manual

Page 14
Step 4 – Attaching and Assembling the Carriage. First attach the Teeter Totter Brackets
(26) to the two square crimps on Top Rail A. Do this by putting Teeter Totter Bracket (26)
on the bottom side of the frame, then fasten it on with the Teeter Totter Top Bracket (29),
5/16” x 1” Bolt (46), Teeter Totter Bracket Washer (65) and, the 5/16” Nylon Nut (61). (The
Bracket Washer goes on before the Nut)
5/16” x 1” Bolt (46), Teeter Totter Bracket Washer (65), Cap (47), and the 5/16” Nylon Nut (61),
Then insert the Carriage and Glider Rods (30) into the Carriage and Glider Base (31)
holes. Bolt on the Carriage Seat Brace (34) to the Carriage Base by using a 5/16” Washer
(64), and Cap Nut (53). NOTE: Make sure the square notches are facing in on the Carriage
Seat Braces.