Owners manual

Page 13
Step 2 – Attach the Gymnast Bars (32) to Top Rail C (following the directions in Step 1
of attaching the swings). If the handles are not attached to the short chains use the 5/16”
Thru Nut (58) to attach them to the chain.
Step 3 – Attach the Glider Chains (67) to the Glider Base (31) by first inserting a Carriage
and Glider Rod (30) into the glider base holes. Then put the one end of the Y from the chain
on the rod and the other end on the same side on the other rod. Fasten them onto the rods by
using a 5/16” Washer (64) and 5/16” cap nut (53). Repeat this on the other side of the glider.
Attach it to the rectangle punched slots on Top Rails C and D (see step 1 on how to attach it
to the top rail).