Owners manual

Page 11
Step 7 – Attach the Lower Frame Leg Poles (9) and Leg Braces (11) (12) to the Upper
Frame Legs. Start on the side with the Top Rail A (has the two square crimps). Slide the
Lower Frame Leg Poles (9) into the upper frame leg. Align the holes. Insert 5/16” x 2”
Bolt (39) with a 5/16” Curved washer (55) into the flat part with hole on Leg Brace (11).
Install this leg brace to the leg (make sure the leg brace is on the outer part of the frame).
Loosely tighten the leg brace, lower frame leg, and upper frame together by bolting it on
with a 5/16” Thru Nut (58) with a 2/5” Curved Washer (54) (see images below). Repeat
this step to attach a Leg Brace (10) on the next two sets of legs.
NOTE: Make sure that the hole at the bottom of the lower leg is facing out
away from the swing set (these holes are used to anchor the swing set down)