Propel XWing Manual

10
Your X-wing’s propeller system is a precision
instrument that may need repair or replacement
from time to time for optimal ight function.
Crash landing from high-speed aerial ights may
cause damage to your propellers.
1. The ship has four propellers, two “A”
Propellers, and two “B” Propellers.
2. When replacing the propeller blades, make sure
to put A propellers on A Motors, and B Propellers
on B motors, as per the diagram at the right.
3. To replace the blade, gently pull o the broken
blade and snap the new correct blade in place by
pushing down rmly.
PROPELLER INSTALLATION AND
REPLACEMENT
A
B
B
A
Multi-Tool:
The multi-tool is used to help install and remove the propellers from the ship.
1. To remove the propeller, wedge the thin side of the multi-tool between the motor
mount and the propeller and push the propeller upwards.
2. To install the propeller use the opposite side of the multi-tool to push down on
the propeller blade. You will notice some pressure and then the blade will move
into place. The proper position of the propeller is when the base of the blade shaft is
seated slightly below the motor hole. Always check to make sure that the blade spins
freely.