Propel XWing Manual

20
on/o
aux weapons
2 bEEP
1 seconds 4 seconds
on/o
white LEDS
1
bEEP
_____________ _____________
R
Ed
-SyNCEd
TO
ShiP
SPEED CHANGE
SPEED 1
SPEED 3
SPEED 2
TMODE
TURN ON/OFF LED’S AND AUX WEAPONS
When the controller is powered on, it will always
start on Speed Mode 1. If the controller was in
Speed Mode 3 before turning it o, it will return to
Speed Mode 1 when it is turned back on.
Push the button to change speeds between Modes
1-3. If you are in Speed Mode 3 and press the
button, you will cycle over to Speed Mode 1.
Flying speed is indicated by the LEDs surrounding
the controller’s power button.
Push the button for 1 second (you will hear
1 beep) to turn on/o the white LEDs that
illuminate your ship. (The red LEDs in the rear of
your ship will remain on.)
Hold down the button for 4 seconds (you will hear
2beeps) to turn on/o your ship’s aux weapons.
Note thatwhen the set of aux weapons are
activated, the IR transceiver will be deactivated,
and vice versa.
Simultaneously push the left and right gimbals
(control sticks) down and in to activate the
emergency stop. This will cut all power to the
motors and the ship will fall to the ground. This is
only to be used in case of emergency, as the ship
may get damaged when it hits the ground.
EMERGENCY STOP