Installation Guide

Table Of Contents

1.As specified in diagram, attach the shower base to the hot and cold water supply pipes

in the wall

4、

7. CLEARANCE AND MAINTENANCE

n order to keep the faucet appearance smooth and good performance, please follow the

below steps to

clean and maintain the faucet.

1. Clean with water and dry with a soft cotton cloth.

2. Use a mild liquid and a colorless glass cleaner to remove surface dirt and scale,

also you can use the cleaner without grinding function.

3. Do not use detergents, polishing tools, abrasive cloth, paper towels or scrapers to clean the faucet.

6、PRODUCT REPARATION

If the cartridge is worn out which cause leakage, please turn off the water source. Remove the handle,

panel, and decorative cover in sequence, remove the gland with a wrench, then take out the cartridge

and copper sleeve. Repair or replace the new cartridge, then install it again in sequence.

4. Do not use acid cleaners, insoluble granular detergents, soaps etc to clean the Faucet.

Installation Instructions

2. Wrap the S-connectors with Teflon tape, and thread the connectors onto the supply

pipes. Tighten with your adjustable wrench.

3.Use a level to verify the connectors are aligned properly. Adjust as necessary.

4. Thread the inner rings onto the S-connectors, keeping the threaded portion facing

outward. Place the escutcheons on the inner rings with the horn mouth facing inward,

and push them against the wall.

5. Attach the connecting nuts to the S-connector, and tighten

7.Attach the middle shower riser to the shower body. Use a level to very that the shower

riser is in the proper location. When all pieces are properly aligned, mark the location of

the mounting bracket on the wall

6. Attach the connecting rod to the middle shower riser. Hold the mounting bracket in

place in the desired mounting location.

9.Attach the shower support and the middle shower riser. Connect the bottom of the riser

to the shower body and the top of the riser to the mounting bracket. Tighten the M6 screw

to secure

8. Remove the middle shower riser, and drill two Ø8 holes at the locations marked in the

previous step. Insert the wall anchors. Attach the mounting bracket to the wall with

mounting screws. Attach the escutcheon to the mounting bracket.

10.Thread the shower head onto the shower support. Tighten the locking nut and shower

head to secure.

11.Connect the hand shower and shower hose.

5、Installation Instructions

3 4