Installation Guide

5. Slide the decorative escutcheons onto the spout
and each handle.
4. Once your finished wall has been completed,
remove the protective plastic sleeves from the valve.
Remove the plug from the spout outlet using a 14mm
socket wrench.
7. Attach the hot and cold handles by sliding them onto
the left and right stems. Secure each handle by
tightening the set screw on the bottom of the handle,
using the provided hex wrench.
8. When your installation is complete, turn on the main
water supply. Use the provided tool to remove the
aerator from the spout. Turn the water on to allow any
dust or loose sediment to clear the system. Allow the
water to flow through the spout for approximately 60
seconds, and verify that hot and cold water are running
properly. Reattach the aerator once testing is
complete.
WALL-MOUNT FAUCET WALL-MOUNT FAUCET
6. Attach the spout to the valve by twisting it into the
middle valve outlet. Apply plumber’s tape or a small
amount of thread sealant to the threads before
attaching.