SHOWER FAUCET Installation Manual
PROOX Show er Set Inst allat ion TOOLS AND MATERIALS: BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing fixtures. We accepts no liability for any damage to the plumbing, floor, walls, tub, or for personal injury during installation. Plumbers Tape Tape Measure Level Adjustable Wrench Hex Wrench Observe all local plumbing and building codes. Unpack and inspect t he product f or shipping damage.
PROOX Show er Set Inst allat ion Step 1: Valve Installation 1. To prepare for installation, wood blocking should be installed between the two studs where the valve will mount. Use the guide printed on the valve’s protective sleeve as a reference when installing the wood blocking. 3. Route, assemble, and connect all in-wall piping to and from the shower valve. Make connections appropriately depending upon the type of pipe that is being used.
PROOX Show er Set Inst allat ion Step 2: Trim Installation 4. Once all piping is routed and connections have been made, use a ½” test plug to perform a water pressure test. Turn on the main water supply to your home and water test the installed plumbing. Ensure that there are no leaks, then shut the water off. Remove the test plug. 1. Once the finished wall is complete, remove the protective sleeves from the valve. If the test plug has not yet been removed, remove that as well.
PROOX Show er Set Inst allat ion 3. Remove the decorative screw cover from the valve handle. Slide the handle onto the valve stem and secure it by tightening the set screw with the provided hex wrench. Reinsert the screw cover to conceal the screw. 5. Attach the hand shower to the cradle using the hand shower hose. Insert one of the provided rubber O-rings into each end of the hose, and apply thread sealant or plumber’s tape to the threads before tightening. Hand tighten the connections firmly. 4.
PROOX Show er Set Inst allat ion 7. Install the shower head using the provided swivel joint. Apply thread sealant or plumber’s tape to the threads before tightening. Once secure, tighten the set screw located on the swivel joint using the provided hex wrench. 8. Turn the main water supply back on, and test the completed shower system. Ensure that there are no leaks and that all functions are working properly.
