Operation Manual

17
English
ON BOARD (users present during the charge proces)
Activate the set-up mode, as described earlier.
A ‘0’ will appear in the display screen. By way of pressing on the ‘mode’ button it
is possible to switch between the green and the red led. Adjust the charger as per the
green led (= factory setting).
After this wait for 10 seconds. A number will now appear in the display screen which
indicates the charging program. By way of repeatedly pressing the ‘mode’ button it is
possible to enter the correct charging program which corresponds to the battery type.
Battery type Suggested charge program
GEL, AGM¹
WET (factory setting)
SEMI TRACTION
TRACTION
CALCIUM, AGM², SPIRAL
After this wait for 10 seconds.
A ‘t’ will appear in the display screen. Now it is possible to determine if the optional
temperature sensor has been connected. By way of pressing the ‘mode’ button it is once
again possible to switch between the green and red led.
Temperature sensor Set the LED to green.
present
Temperature sensor
isn’t present Set the LED to red.
(factory setting)