User's Manual

Operation sequence:
1. You need to plug the AC power adapter on AC power socket.
2. Take its DC plug into Router DC power socket. (“Power”)
3. Put the power switch (Text “SW”) from low to high position.
4. Then the router will spend a minute to start.
5. Power LED and WLAN LED will light until you turn off the power
switch.
6. All LAN and WAN LED will blink once and then, starting to check
each port, those LED blink one by one. After that, All LWAN and
WAN LED shall blink again, finally, it will lights when port has
Ethernet signal normal (it means you were put Ethernet cable into
router and another side has Ethernet device live.)
7. If USB port has device insertion, also it will light.
8. Set your NIC (Network Interface Card) in PC, its IP to the this value:
IP: 192.168.0.1 , Mask: 255.255.255.0 , Gateway: 192.168.0.253
(The Router LAN IP is 192.168.0.253)
9. You can try to use Web Browser (Like as Microsoft IE or Mozilla
Firefox) and type LAN IP which you defined (Default setting is
192.168.0.253) to address bar then press “Enter”.
10. The Web Browser will open the webpage a few seconds. If no, check
your physical network condition and TCP/IP setting in your system to
debug your connection. (or if you cannot access the Router, Please
press Reset-button over than 5 seconds to restore default!
(Reset-button is posited between Power socket and LED))
11.