Product manual

VTrak E-Class Product Manual

In the above example, the IP addresses and subnet mask are included as

examples only. Your values will be different.

If you prefer to let your DHCP server assign the IP addresses, type the

following strings, then press Enter.

administrator@cli> net -a mod -t mgmt -m -c 1 -s "dhcp=enable"

administrator@cli> net -a mod -t mgmt -m -c 2 -s "dhcp=enable"

Note that the IP address described above belongs to the RAID controller, not

to the VTrak subsystem. Use this IP address to log into the controller over

your network.

5. To verify the maintenance mode settings, type net -m and press Enter.

administrator@cli> net -m

– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –

CtrlId: 1 Port: 1

Type: Management Ethernet IPType: IPv4

IP: 192.168.10.101 IPMask: 255.255.255.0

MAC: 00:01:55:AE:02:AE DNS: 0.0.0.0

Gateway: 192.168.10.1 DHCP: Disabled

This completes the Management port setup. Go to “Creating Disk Arrays with

WebPAM PROe” on page 42.

To see the full set of CLI commands, at the admin@cli> prompt, type help and

press Enter.