Product manual

Chapter 8: Troubleshooting
267
Figure 6. Battery and Fan LEDs (left: E610f/s, right: E310f/s)
Under normal conditions, the power supply and fan LEDs should display green.
To check a component’s installation, follow the same procedure as replacing the
component, except that you reinstall the original component rather than a new
one. In most cases, this action fixes a bad connection and allows VTrak to detect
the component. If this action does not correct the problem, replace the unit. See
page 213 for instructions.
The Controller Location LEDs, on the back of the VTrak subsystem, will flash for
one minute.
Figure 7. The VTrak E610f/E310f controller LEDs
LEDs
State
Dark Green Amber Red
Power supply Not detected OK Fan failed Failed
Battery Not detected OK
Fan Not detected OK Wrong speed Failed
Fan LED
Fan
LED
Battery
LED
Battery LED
Mgmt
UPS
115200
8 N 1
FC 1 FC 2
4
2
1
Gb/s
4
2
1
Gb/s
Status LED
Dirty Cache LED