Product manual

VTrak E-Class Product Manual
58
To enable automatic maintenance mode settings:
1. From the CLU Main Menu, highlight Network Management and press Enter.
2. Highlight Maintenance Mode Network Configuration and press Enter.
3. Highlight the controller you want and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Enabled.
5. Press Control-A to save your settings and move to the Maintenance Mode
IPv6 settings screen.
Making Maintenance Mode Settings – Manually under IPv4
To make maintenance mode IPv4 manual settings:
1. From the CLU Main Menu, highlight Network Management and press Enter.
2. Highlight Maintenance Mode Network Configuration and press Enter.
3. Highlight the controller you want and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Disabled.
5. Highlight each of the following and press the backspace key to erase the
current value, then type the new value.
• IP address
• Subnet Mask
• Default Gateway IP address
• DNS Server IP address
6. Press Control-A to save your settings and move to the Maintenance Mode
IPv6 settings screen.
Making Maintenance Mode Settings – Manually under IPv6
To make maintenance mode IPv6 manual settings:
1. From the CLU Main Menu, highlight Network Management and press Enter.
2. Highlight Maintenance Mode Network Configuration and press Enter.
3. Highlight the controller you want and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Disabled.
5. Highlight each of the following and press the backspace key to erase the
current value, then type the new value.
• IP address
• Subnet Mask
• Default Gateway IP address
• DNS Server IP address
6. Press Control-A to save your settings and:
• If you made settings for Controller 1, move to the Maintenance Mode
settings for Controller 2.