Product manual

VTrak E-Class Product Manual
368
iSCSI on a VLAN
VTrak supports up to 32 iSCSI portals per iSCSI port. Each iSCSI portal can
belong to a different VLAN for a maximum of 32 VLANs.
See the diagram on page 335, Figure 2.
To set up the VTrak subsystem for a VLAN:
1. Add a new portal with a VLAN association.
See “Adding iSCSI Portals” on page 194 or page 264.
Note which iSCSI port you chose for the portal.
2. Add a new target.
See “Adding iSCSI Targets” on page 190 or page 259.
3. Assign the new portal with VLAN assocation to the target.
See “Assigning a Portal to an iSCSI Target” on page 192. The CLU assigns
portals when you add the target. See page 259.
4. Map the target to a LUN.
See “Adding a LUN Map” on page 180 or page 280.
5. Connect your iSCSI data cable to the iSCSI port you chose for the new
portal.
See “iSCSI Storage Area Network (SAN)” on page 34.
6. Add your iSCSI intiators to the VTrak’s initiator list.
See “Adding an iSCSI Initiator” on page 178 or page 278.
For information, see:
• “Managing iSCSI Connections” on page 188 or page 257.
• Visit the Promise Knowledgebase at http://kb.promise.com/ and access topic
“10188 – Setting up Microsoft iSCSI Initiator With the VTrak.”