Product manual

Chapter 5: Management with the CLU
299
2. Highlight Software Management and press Enter.
3. Highlight SNMP and press Enter.
4. Highlight Trap Sinks and press Enter.
5. Highlight Create New Trap Sink and press Enter
6. Highlight Trap Sink IP address and press the backspace key to erase the
current value, then type the new IP address in this field.
7. Highlight Trap Filter and press the spacebar to toggle through the severity
levels.
See the Table below.
8. Press Control-A to save the Trap Sink.
Deleting a Trap Sink
To delete a trap sink:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight SNMP and press Enter.
4. Highlight Trap Sinks and press Enter.
5. Highlight the trap sink you want to delete and press the spacebar to mark it.
The mark is an asterisk (*) to the left of the listing.
6. Highlight Delete Marked Entries and press Enter.
Making CIM Settings
By default, Common Information Model (CIM) service is set to Automatic and its
normal status is Started.
Event Severity Levels
Level Description
Fatal Non-recoverable error or failure has occurred.
Critical Action is needed now and the implications of the condition are
serious.
Major Action is needed now.
Minor Action is needed but the condition is not a serious at this time.
Warning User can decide whether or not action is required.
Information Information only, no action is required.