Product manual

VTrak E-Class Product Manual
264
• ProtocolFamily – IPv4 or IPv6.*
• PrimaryIP – Primary IP address of this portal.*
• PrimaryIPMask – Subnet mask of this portal.*
• AssignedTarget – 0 is the default target. The number of targets
available depends on how many targets you create. See “Adding iSCSI
Targets” on page 259.
Items marked with an asterisk (*) are adjustable under “Making iSCSI Portal
Settings” on page 265.
Adding iSCSI Portals
VTrak supports up to 32 iSCSI portals per iSCSI port. Each iSCSI portal can
belong to a different VLAN for a maximum of 32 VLANs.
If you plan to associate the new portal with a trunk, create the trunk first. See
“Adding iSCSI Trunks” on page 271.
For more information about iSCSI VLANs, see “iSCSI on a VLAN” on page 368.
To add an iSCSI portal:
1. From the Main Menu, highlight iSCSI Management and press Enter.
2. Highlight iSCSI Portals and press Enter.
The list of iSCSI Portals displays.
3. Highlight Create New Portal and press Enter.
4. Highlight AssociatedType and press the Spacebar to toggle through PHY,
VLAN, and Trunk.
5. If you chose:
• PHY – Choose a Controller ID (1 or 2) and a Port ID (1 to 4).
• VLAN – Choose a Controller ID (1 or 2), a Port ID (1 to 4), and a
VLANTag (0 to 4094).
• Trunk – Choose a Trunk ID (1 to 8).
To change an ID number, highlight the item, press Backspace to delete the
current ID and type a new ID.
6. Highlight DHCP and press the Spacebar to toggle between Enable and
Disable.
Note that DHCP is currently supported only for IPv4.
7. If you chose DHCP Disable:
• Choose a Protocol Family (IPv4 or IPv6).
• Enter a Primary IP address.
• Enter a Primary IP mask or subnet mask.