Product manual

VTrak E-Class Product Manual
100
Managing Network Connections
Network Connections Management includes the following functions:
• Making Virtual Management Port Settings (page 100)
• Making Maintenance Mode Settings (page 100)
Making Virtual Management Port Settings
The VTrak subsystem has a virtual management port, enabling you to log into a
VTrak with dual controllers using one IP address.
Before you change settings, please see “About IP Addresses” on page 45.
You initially made these settings during subsystem setup. You can change them
later as required.
To make virtual management port settings:
1. Click the Device tab.
2. Click the Network Management icon.
3. Click the Virtual Management Port tab.
4. Click the protocol family whose settings you want to change and click the
Configuration button.
5. Make the following settings are needed:
• Check the Enable box to enable this protocol family.
• Check the Enable DHCP box to enable a DHCP server to make your
network settings. DHCP is currently supported in IPv4 only.
• For manual network settings, type the RAID subsystem’s IP address,
subnet mask, gateway IP address, and DNS server IP address into the
fields provided.
6. Click the Submit button.
Making Maintenance Mode Settings
Each controller has its own IP addresses for access when the controller goes into
maintenance mode. For more information, see “Maintenance Mode” on
page 395.
Before you change settings, please see “About IP Addresses” on page 45.
Caution
Changing virtual management port settings can interrupt your
WebPAM PROe connection and require you to log in again.