Product manual

ChangE nEtwork sEttings
In order to use the Activate Automatically option in the License Wizard, the VTrak requires Internet
access. The Network Setup menu allows you to change the IP settings of the Virtual Management Port to suit the
preferred IP arrangement used on you network.
The VTrak A-Class uses a static IP address so the IP address used for the Meta Data communications network
can only be changed by the administrator. If the Meta Data network is shared with the general local IP network
or if a DHCP server is running anywhere on the Meta Data network, it is a good idea to remove the IP address
assigned to the VTrak from the DHCP pool of available IP addresses on your network.
The following network settings can be congured:
Virtual Management Port
IP Address
This is the IP address used for Meta Data communications. All FS Clients
must be on the same subnet with this IP address.
Controller 1 Port IP Address /
Controller 2 IP Address
This is the IP address used for Maintenance Mode port on Controller 1
and Controller 2. All FS Clients must be on the same subnet with this IP
address.
Subnet Mask Make sure the FS Clients are using the same Subnet Mask.
Gateway IP Address This and the DNS IP address are required for Internet access. Use the
Internet gateway IP address for your network.
DNS IP Address This is required for Internet access. Can use an internal or external DNS
server.
Note
If the VTrak IP settings are changed to a subnet that is inaccessible by the computer
being for access, WebPAM PRO will log you out automatically. It will be necessary to
login again from a computer within the new subnet.
40
VTrak A-Class Product Manual Promise Technologies