Product manual

speCIfICAtIons

VTrak A3000 Series

System Architecture IntegratedVTrakFSclusteredlesystem

Upto8simultaneouslesystemspersystem

Serveupto1Billionles

Expansion Capacity VTrakx30ExpansionChassisorVTrakx30Fibre

ChannelRAIDStorageSystems

Fibre Channel Data Interface Four8GbFibreChannelportspercontroller(8totalports

forhighavailabilitysystems)

RAID Support RAID0,1,1E,5,6,10,50,60

Directory Services LDAP,ActiveDirectory,OpenDirectory

Green RAID Fourlevelsofadvancedpowermanagementdiskdrive

(MAID)support

Efcient80PlusCertiedpowersupplies

Management Interfaces EmbeddedmanagementusingVTrakA-Class

managementSoftware(viaEthernet)

CommandLineInterface(SerialPortorEthernetvia

telnetandSSH)

ThirdPartyManagementSupportviaSNMP

Operating Systems

Supported

ClientsupportforLinux,WindowsandMacOSX

Note

The factory default virtual IP addresses used for system management are:

• IPv4 - 10.0.0.1

The virtual management port IP address works with either RAID controller, enabling

you to access a dual-controller VTrak over your network using a single IP address.

The default physical management port IP addresses are set to:

• Controller 1, IPv4 – 10.0.0.2

• Controller 2, IPv4 – 10.0.0.3

The physical management port IP address works with only one RAID controller and is

used when the controller goes into maintenance mode.

Introduction