Product manual

VTrak M-Class Product Manual
206
4. Highlight Restore Factory Defaults and press Enter.
5. Press Y to confirm the reset.
Shutdown and Restart
This function enables you to shutdown or restart the VTrak subsystem. You can
only do part of this function in the CLU. Additional action is required, as described
below. What you see on the screen differs whether you have a Telnet or serial
connection.
To shutdown the VTrak subsystem (Telnet connection):
1. Press the spacebar to display “Shutdown” then press Enter.
A warning message appears.
2. Press Y to continue.
The screen will go blank.
3. Wait for no less than two minutes.
4. Manually turn off the power supply switches on the back of the subsystem.
To shutdown the VTrak subsystem (serial connection):
1. Press the spacebar to display Shutdown then press Enter.
A warning message appears.
2. Press Y to continue”
3. When this message appears:
Shutdown complete. It is now safe to power off
the subsystem.
turn off the power supply switches.
To restart the VTrak subsystem (Telnet connection):
1. Press the spacebar to display Restart then press Enter.
A warning message appears.
2. Press Y to continue.
The screen will go blank.
3. Wait for two to three minutes.
4. Re-establish your Telnet connection to the VTrak CLU.
If you cannot re-establish a connection, wait 30 seconds, then try again.
To restart the VTrak subsystem (serial connection):
1. Press the spacebar to display Restart then press Enter.
A warning message appears.
2. Press Y to continue.