Product manual

Chapter 5: Management with the CLU
205
1. Highlight the trap sink you want to delete and press the spacebar to mark it.
The mark is an asterisk (*) to the left of the listing.
2. Highlight Delete Marked Entries and press Enter.
CIM
1. Highlight CIM and press Enter.
2. Highlight Startup Type and press the spacebar to toggle between Automatic
and Manual.
3. Press Ctrl-A to save your settings.
To start, stop or restart the CIM service, highlight Start, Stop or Restart and press
Enter.
Flash through TFTP
Use this function to flash the VTrak’s firmware. See “Firmware Update – CLU” on
page 213 for this procedure.
Clear Statistics
This function clears the statistical counts for the RAID controller, Fibre Channel
ports, iSCSI ports, physical drives and logical drives.
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Clear Statistics and press Enter.
3. Press Y to confirm the deletion.
Restore Factory Defaults
This function restores the factory default settings to the firmware and software
items you select.
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Restore Factory Defaults and press Enter.
3. Highlight the setting group you want and press the spacebar to toggle
between Yes and No.
Yes means this setting will be restored to the default value.
Caution
Use this function with care. Do not restore to default settings for
any item unless you are sure this action is needed.