Product manual

Chapter 5: Management with the CLU
199
Delete Initiator
1. Highlight the initiator you want to delete and press the spacebar to mark it.
The mark is an asterisk (*) to the left of the listing.
2. Highlight Delete Marked Initiators and press Enter.
3. Press Y to confirm the deletion.
Map a LUN to an Initiator
1. Highlight an existing Initiator and press Enter.
A list of logical drives displays.
2. In the LUN field, press the backspace key to erase the current value, then
type the LUN you want to assign to this initiator, from 0 to 255.
If you make a error, press Ctrl-R to restore the current LUN.
3. Press Ctrl-A to save the LUN map.
LUN Mapping (SCSI)
This function enables you to assign a Target and LUN to each logical drive, so
the SCSI initiator can recognize it.
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight LUN Mapping and press Enter.
3. Highlight a SCSI Channel and press Enter.
A list of the current logical drives appears.
You must enable a Target under SCSI Management before you can assign a LUN
to it. See “Channel Settings” on page 192.
To assign a Target and LUN to a logical drive:
1. Highlight the logical drive you want from the list.
2. Under Target ID, type the Target number you want to use.
Target IDs range from 0 to 15.
3. Press the right arrow key to move to the LUN column.
4. Under LUN, type the LUN number you want to use.
LUNs range from 0 to 63. The number of available LUNs may be less,
depending on the capability of your SCSI HBA card.
5. Press Ctrl-A to save the LUN Map.
If the logical drive displays in red, the Target you selected is not enabled.
If you select an invalid LUN, this message displays: "WARNING: Target X has no
LUN 0 defined!"