Product manual

Chapter 4: Management with WebPAM PROe
133
2. Click on the Disk Arrays icon.
3. Click on the Disk Array icon.
4. Click on the Settings tab in Management View.
5. Enter an alias in the Disk Array Alias field.
Maximum of 32 characters. Use letters, numbers, space between words
and underscore. An alias is optional.
6. To enable Media Patrol support, check the Media Patrol box.
7. To enable PDM support, check the PDM box.
8. Click the Submit button.
Create a Logical Drive
The Disk Array–Create LD tab enables you to create additional logical drives
under this disk array. When you create a disk array, you automatically create one
logical drive also. If the initial logical drive used less than the full capacity of the
disk array, you can create additional logical drives from the same disk array.
To create a logical drive:
1. Click the Subsystem icon in Tree View.
2. Click on the Disk Arrays icon.
3. Click on the Disk Array icon.
4. Click on the Create LD tab in Management View.
5. Enter an alias (name) in the Alias field.
Maximum of 32 characters. Use letters, numbers, space between words
and underscore. An alias is optional.
6. From the RAID Level dropdown list, select a RAID level for this logical drive.
All RAID levels supported by the disk array appear in the list. See “Choosing
a RAID Level” on page 241.
7. Enter a capacity and select unit of measure (MB, GB, TB).
The default value is the available capacity of the disk array. You can use this
value or any lesser amount.
8. From the Stripe dropdown menu, select a Stripe size for this logical drive.
The choices are 8, 16, 32, 64, 128, 256, 512 KB and 1 MB. 64 KB is the
default. See “Stripe Size” on page 244.
9. From the Sector dropdown menu, select a Sector size for this logical drive.
The choices are 512 B, 1, 2, and 4 KB. 512 B is the default. See “Sector
Size” on page 244.