User Manual

Virtual MaNageMeNt port settiNgs (cli)
MAking virtuAl MAnAgeMent POrt settings – AutOMAticAlly (cli)
Automatic settings require a DHCP server on your network. DHCP is currently supported on IPv4 only.
To enable automatic management port settings:
1. At the command prompt, type net -a mod -f ipv4 -s “dhcp=enable” and press Enter.
administrator@cli> net -a mod -f ipv4 -s “dhcp=enable”
After a moment, the comand prompt reappears, indicating that your setting was successful.
administrator@cli>
2. To verify the setting change, at the command prompt, type net and press Enter. The following
information displays:
administrator@cli> net
==========================================
PF Status IP Link
==========================================
IPv4 Enabled 10.0.0.1 Up
IPv6 Disabled :: Up
In the above example:
• PFreferstoIPprotocolfamily,v4orv6
• StatusreferstowhethertheIPprotocolisenabled.IPv4isenabledbydefault.
• IPisthevirtualmanagementportIPaddress.
• Linkindicateswhetherthereisaworkingnetworkconnection.
By default, IPv4 is enabled and IPv6 is disabled.
72
Vess R2000 Series Product Manual Promise Technologies