User Manual

ABout IP ADDReSSeS
• “DefaultIPAddresses”onpage67
• “ChoosingDHCPoraStaticIPAddress”onpage68
• “AccessingtheMACAddressintheCLI”onpage69
• “AccessingtheMACAddressintheCLU”onpage70
Choosing the appropriate IP addresses is essential to manage your Vess R2000 subsystem over a network. You
must change the IP addresses of the subsystems as required for your environment.
deFault ip addresses
The default virtual management port IP addresses are set to:
•
IPv4–10.0.0.1
• IPv6–2001::1
The virtual management port IP address works with either RAID controller, enabling you to access a dual-
controller Vess R2000 over your network using a single IP address.
The default
physical management port IP addresses are set to:
•
Controller1,IPv4–10.0.0.2
• Controller1,IPv6–2001::2
• Controller2,IPv4–10.0.0.3
• Controller2,IPv6–2001::3
The physical management port IP address works with only one RAID controller. The port is used for management
of the subsystem and when a controller is in maintenance mode. See “Maintenance Mode” on page 626.
67
Product Manual Setup