User Manual

664
Vess R2000 Series Product Manual Promise Technologies
Reported Event Corrective Action
Synchronization
Synchronization is started
Noactionisrequired.
Synchronization is completed
Noactionisrequired.
Synchronization is paused
Resumesynchronizationwhenready.
Synchronization is resumed
Noactionisrequired.
Synchronization is stopped
Synchronization is aborted due to an internal
error.
ReducesystemloadontheVess.
Synchronization is queued
Noactionisrequired.
Synchronization is stopped internally
Subsystem (Vess)
The Subsystem is started
Noactionisrequired.
The Subsystem is stopped
Subsystem parameter(s) are changed by user
System is set to Redundant mode
System is set to Critical mode
Checkcontrolleroperation.
System is set to Non-Redundant mode
Ifyoursystemhastwocontrollers,check
controlleroperation.
Transition
Transition is started
Noactionisrequired.
Transition is completed
Transition is paused
Resumetransitionwhenready.
Transition is resumed
Noactionisrequired.
Transition is stopped
Ifthisactionwasnotintentional,checkthe
diskarray’sstatus.
Transition was switched to rebuild
Replacethedeadphysicaldriveor
reinstallthemissingdrive.
Unknown
Unknown priority reason is detected
Ifthismessageappearsrepeatedly,
contactTechSupport.
Zoning
Zoning permission settings with the expander
has been reset to defaults
Noactionisrequired.
Zoning expander has been rebooted.
Zoning permission settings with the expander
different than expected
Settingshavebeenupdatedcorrectly.No
actionisrequired.