User Manual

629
Product Manual Troubleshooting
6. At the MAINTENANCE MODE@cli> prompt, type maintenance -a exit and press Enter.
The controller reboots. The login screen again appears.
7. Close the Serial connection.
Telnet Connection
This procedure requires you to know the IP address of the controller.
To clear maintenance mode using a Telnet connection:
1. Go to the command line prompt (Windows) or click the terminal icon (Linux), then run:
telnet 192.168.1.56 2300
The IP address above is only an example. 2300 is the default Telnet port for Vess.
The login screen appears.
The following steps show the default Administrator user name and pass-word. Use your own user name and
password if you have changed these.
2. At the Login prompt, type administrator and press Enter.
3. At the Password prompt, type password and press Enter.
The CLI screen appears.
The prompt should display MAINTENANCE MODE@cli>. If the prompt dis-plays your login name, such as
administrator@cli>, log into the other controller.
4. At the MAINTENANCE MODE@cli> prompt, type maintenance -a exit and press Enter.
The controller reboots. The Telnet session ends.