User Manual

Support ange on the front
end of each rail
Front right label
Front left label
Guide pins on rails align with holes in the rack post
Caution
Tolightentheenclosure,removethepowersupplies,andremoveall
harddrivecarriers.Replacethepowersuppliesanddrivecarriers
aftertheunitismountedinyourrack.
To install the Vess into a rack with the supplied mounting rails:
1. Check the t of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
•
Therearrailslidesinsidethefrontrail.Therailsarecomposedoftwoslidingsectionsanddonotrequire
adjustingscrews.
• Thefront-leftandfront-rightmountingrailendsarelabeled.
• Besurethefrontrailsupportisonthebottomfacinginward.
Installing the rails onto the rack
• Allrailends,frontandrear,attachattheoutsideoftherackposts.
• Theguidepinsattherailendsalignwiththeholesintherackposts.
• Usetheattachingscrewsandangenutsfromyourracksystem.Tightenthescrewsandnutsaccording
toinstructionsforyourracksystem.
31
Product Manual Hardware Installation