User Manual

466
Vess R2000 Series Product Manual Promise Technologies
MakiNg MaiNteNaNCe Mode settiNgs (Clu)
Each controller has its own IP addresses for access when the controller goes into maintenance mode. For more
information,see"MaintenanceMode"onpage112.
Before you change settings, please see “About IP Addresses” on page 36.
MAking AutOMAtic settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight MaintenanceModeNetworkConguration and press Enter.
3. Highlight the controller (CId 1 or 2) and protocol family (IPv4 or IPv6) you want and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Enabled.
5. Press Control-A to save your settings.
MAking MAnuAl settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight MaintenanceModeNetworkConguration and press Enter.
3. Highlight the controller (CId 1 or 2) and protocol family (IPv4 or IPv6) you want and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Disabled.
5. Highlight each of the following and press the backspace key to erase the current value, then type the new
value.
• IP Address
• Subnet Mask
• Default Gateway IP Address
• DNS Server IP Address
6. Press Control-A to save your settings.