User Manual

455
Product Manual Manage with CLU
5. Highlight the following parameters and press the backspace key to erase the current value:
• Alias–Typeanaliasintotheeld,ifdesired.Maximumof32characters.
Useletters,numbers,spacebetweenwordsandunderscore.
• RAID Level-Press the spacebar to toggle though a list of available RAID levels.
• Capacity
–Maximumcapacityshown.Enterasmallercapacityifdesired.
6. Highlight the following parameters and press the spacebar to toggle though the available choices:
• Stripe size–Pressthespacebartochoose:64KB,128KB,256KB,512KB,or1MB.
• Sector size–Pressthespacebartochoose:512B;1KB,2KB,or4KB.
• Write Policy–Pressspacebartochoose:WriteBackorWriteThrough.
• Read Policy–Pressspacebartochoose:NoCache,ReadCache,orReadAheadCache.
7. Highlight Preferred Controller ID and press the spacebar to toggle among 1, 2, or Automatic.
8. Highlight PerfectRebuild and press the spacebar to toggle Enable or disable.
9. RAID 30, 50 and 60 only. Highlight Number of Axles and press the spacebar to choose the number of
axles.
10. Highlight Save Logical Drive and press Enter.
Note
If you did not use all of the available capacity of the disk array, you can
create an additional logical drive at this point.