User Manual

307
Product Manual Managing with the CLI
arraywillbecomeofine.
Theusercandoanaccepttoacknowledgetheincompleteconditionofthe
array,andtrytorecovertheaccesstothearrayandlogicaldrivesonthe
array,inotherwords,tobringthelogicaldrivesonline.However,itisahigh-
riskandnon-revertibleoperation,anditmayresultindataloss.
Therefore,itisrecommendedtotrytocleartheconditionrst,e.g.,toputthe
missingdrivesback;ortoroamthearraybacktotheoriginalcontrollerandwait
untilthemigrationcompletes.
transport Togracefullymakethearrayandthelogicaldrivesonthearray
 ofinetogetreadyfortransportthearraytoanothersubsystem.
untransport Cancelsthetransportactiononthearrayandthelogicaldrives.
 Bringsthearraybackonlineintheoriginalsubsystem.
 NotsupportedforHBAproducts.
online Tosetallthedeadphysicaldrivesofarrayonlineatatime.
-d<DAID> ThediskarrayID.Validvaluesare0-255.Usedtospecifythe
 desiredarrayIDwhencreating(add)anarray.
 UsedtospecifythearrayIDwhenlistingarrayinformation 
 modifying,deleting,locating,accepting,addingordeletinga
 logicaldrive.Onlyonearraymaybespecied.
-p<PDIDlist> Usedtospecifywhichphysicaldrivesaretobeusedinanarray.
 Usedinconjunctionwith-aadd.PDIDscanbeusedsinglyor
 separatedbycomma.Additionallyasequentialgroupofphysical
 drivescanbespeciedbyplacinga~betweennumberssuchas
 1~6.Thiswillincludephysicaldrives1,2,3,4,5,6.
-s“<option>=<value>” Usedtospecifysettingsforanarray.Thisisusedwhencreating
 (add)ormodifying(mod)anarray.Theseoptionsarecomma
 separated.