User Manual

281
Product Manual NAS Function and Management
To create a Replication Backup for a Share Disk, follow these steps:
1. In NAS conguration: Backup > Replication Backup
2. Click the Create button, enter conguration settings for the Replication.
• EntertheIPaddressoftheRemoteBackupServer(aseparateNAS)
• ChooseaPolicyforreplication:Mirror Modesyncsaddedandmodiedles
andmirrorsledeletion,Copy Modesyncsaddedandmodiedlesand
doesNOTdeleteanylesthatweredeletedonthesourceShareDisk.
• OptionalsettingsincludeEncryption(checkboxtoenable)changing
thePortonthebackupserver.TochangethedefaultPortnumber,
unchecktheboxandtypeintheportnumbertouse.
• ChoosethePortalIPfortheNASfromthedrop-downmenu.
• ChoosetheScheduletypetouseforsyncing.NotethatthedefaultvalueDisable
meansthereplicationisdonemanually(see“RunReplicationBackup”below).
• ChoosethenumberofRetryTimes,thenumberoftimestotryagainiftheconnectionfails.
• ConnectionTimeoutisthetimeinsecondsallowedforthe
connectiontobeidlebeforedisconnecting.
• ChangetheMaximumTransferRateifyouwanttolimittherateatwhich
thetransferisallowedtoproceed.Bydefault,thisisunlimited.
3. Click the Next button to proceed.
The connection will rst be validated.
4. If the connection to the server is made, choose Share Disks with identical names on both ends of the
backup connection, that is, the source and destination Share Disk must have the same name.
5. Click the Apply button to create the Replication Backup settings.
Create Replicaon Backup menu