User Manual

195
Product Manual WebPAM PROe - System Conguration
prepariNg a disk array For traNsport
This feature prepares the physical drives that make up the disk array to be removed from the enclosure and
installed in a different location.
To prepare a disk array for transport:
1. Click the Storage tab.
2. Click the Disk Array icon.
The list of disk arrays appears.
3. Clickthediskarrayyouwant,thenclicktheTransport button.
4. Click the Conrm button.
The status changes to
Transport Ready .
5. Remove the physical drives and install them in their new location.
Formoreinformation,see“Installing Physical Drives” on page 34.
rebuildiNg a disk array
When you rebuildadiskarray,youareactuallyrebuildingthedataononephysicaldrive.
If there is no spare drive of adequate capacity and the Auto Rebuild function is DISAB LED,youmustreplace
the failed drive with an uncongured physical drive, then perform a Manual Rebuild.  See “Making Rebuild
Settings” on page 152.
Important
If your replacement disk drive was formerly part of a different disk array or
logicaldrive,youmustclearthecongurationdataonthereplacementdrive
before you use it. See “Clearing a Stale or a PFA Condition” on page 186.