User Manual

135
Product Manual WebPAM PROe - System Conguration
MakiNg MaiNteNaNCe Mode settiNgs
Each controller has its own IP addresses for access when the controller goes into maintenance mode.
Beforeyouchangesettings,pleaseSee“About IP Addresses” on page 67.
To make maintenance mode settings:
1. Click the Administration tab.
2. Click the Network Management icon.
3. Click the Maintenance Mode tab.
4. Click the controller and protocol family whose settings you want to change and click the Conguration
button.
5. Make the following settings are needed:
• Checkthe Enablebox toenablethisprotocolfamily.
• ChecktheEnable DHCPboxtoenableaDHCPservertomakeyour
networksettings.DHCPiscurrentlysupportedinIPv4only.
• Formanualnetworksettings,typetheIP address, subnet mask, gateway
IP address,and DNS server IP addressintotheeldsprovided.
6. Click the Submit button.