User Manual

134
Vess R2000 Series Product Manual Promise Technologies
MAnAgIng netwoRk connectIonS
Network Connections Management includes the following functions:
• “Making Virtual Management Port Settings” on page 134
• “Making Maintenance Mode Settings” on page 135
MakiNg Virtual MaNageMeNt port settiNgs
The Vess R2600 subsystem has a virtualmanagementport,enablingyoutologintoaVessR2600withdual
controllers using one IP address.
Beforeyouchangesettings,pleaseSee“AboutIPAddresses”onpage36.
You initially made these settings during subsystem setup. You can change them later as required.
Caution
Changing virtual management port settings can interrupt your
WebPAM PROe connection and require you to log in again.
To make virtual management port settings:
1. Click the Administration tab.
2. Click the Network Management icon.
3. Click the Virtual Management Port tab.
4. Click the protocol family whose settings you want to change and click the Conguration button.
5. Make the following settings are needed:
• ChecktheEnableboxtoenablethisprotocolfamily.
• ChecktheEnable DHCP boxtoenableaDHCPservertomakeyour
networksettings.DHCPiscurrentlysupportedinIPv4only.
• Formanualnetworksettings,typetheRAIDsubsystem’sIPaddress,subnetmask,
gatewayIPaddress,andDNSserverIPaddressintotheeldsprovided.
6. Click the Submit button.