User Manual

MAking MAintenAnce MOde settings – MAnuAlly under iPv6 (cli)
You make these settings for one controller at a time.
To make maintenance mode settings:
1. At the command prompt, type net -a enable -f ipv6 -m -c 1 and press Enter to enable IPv6.
After a moment, the comand prompt reappears, indicating that your setting was successful.
administrator@cli>
2. At the command prompt, type net -a mod -m -c 1 -s “ followed by:
• primaryip=andtheIPaddress,
• primaryipmask=
andthesubnetmask,
• primarydns=
andtheDNSserverIPaddress,
• gateway=
andtheGatewayserverIPaddress
“ andpressEnter.
Example:
administrator@cli> iscsi -a mod -t portal -s
“primaryip=2001:0db8:85a3:0000:0000:8a2e:0370:7336, primaryip
mask=2001:0db8:fedc:ba98:7654:3210:0246:8acf,
primarydns=2001:0db8:85a3:0000:0000:8a2e:0370:7001,
gateway=2001:0db8:85a3:0000:0000:8a2e:0370:7002”
After a moment, the comand prompt reappears, indicating that your setting was successful.
administrator@cli>
79
Product Manual Setup