User Manual

MAking MAintenAnce MOde settings – MAnuAlly under iPv4 (cli)
You make these settings for one controller at a time.
To make maintenance mode settings:
1. At the command prompt, type net -a mod -m -c 1 -s “ followed by:
• primaryip=andtheIPaddress,
• primaryipmask=
andthesubnetmask,
• primarydns=
andtheDNSserverIPaddress,
• gateway=
andtheGatewayserverIPaddress
“ andpressEnter.
Example:
administrator@cli> net -a mod -m -c 1 “primaryip=10.0.0.101,
primaryipmask=255.255.255.0,primarydns=10.0.0.11,gatew
ay=10.0.0.1”
After a moment, the comand prompt reappears, indicating that your setting was successful.
administrator@cli>
2. To verify the settings changes, at the command prompt, type net -a list -m and press Enter.
77
Product Manual Setup