Product manual

VessRAID 1000f, 1000i, 1000s Series Product Manual
404
Network Connections
Each controller has one Ethernet RJ45 connector on the back of the enclosure
for the Management port and four RJ45 connectors for the iSCSI ports. The
VessRAID becomes a node on your network like any other PC or server.
VessRAID supports DHCP. If there is a DHCP server on your network, do not
assign an IP address manually without consulting your network administrator.
Management Port
VessRAID ships from the factory a default Management Port IP address of
10.0.0.1. You must change this address to one that will work with your network.
See “Chapter 3: VessRAID Setup” on page 41.
Figure 19.Management port connection
iSCSI Ports
VessRAID ships from the factory default iSCSI Port IP addresses of 10.0.0.2
through 10.0.0.5. You must change these addresses to work with your GeE
network. See “Chapter 3: VessRAID Setup” on page 41 or “Making iSCSI Port
Settings” on page 83 (WebPAM PROe) or page 249 (CLU).
LEDs
State
Dark Green Flashing Green
Activity No activity — Activity
Connectivity 10BaseT 100BaseT —
Connectivity LED
Activity LED