Product manual

Chapter 7: Maintenance
231
Figure 8. Removing the RAID Controller
2. Lay the RAID Controller on a non-static surface and remove the cover
attaching screws, one on each side, then remove the cover.
See page 227, Figure 3.
3. Gently press the retainers outward until the memory module pops out of the
memory slot.
Figure 9. RAID Controller memory module
4. Align the new memory module with the memory slot so the groove lines up.
5. Gently press the memory module into the slot until the retainers click into
locked position.
6. Attach the RAID Controller cover and install the two attaching screws.
See page 227, Figure 3.
7. Reinstall the RAID Controller.
See “Replacing a RAID Controller” on page 225.
This completes the memory module replacement procedure.
Thumbscrew Latch
Memory
module
RetainerRetainer Memory
slot
Alignment
groove